A welder in Gary bet me 20 bucks I couldn't hand-tighten a 3/4 inch tube roll, and now I check torque before every seal

Parker Williams · 2026-11-02T06:45:04.164815+00:00

Lost the bet and blew out a tube sheet gasket on a boiler demo an hour later, so I bought a cheap beam torque wrench that afternoon and haven't hand-hung a roll since, anybody got a favorite beam wrench that survives a shop floor?

Babble Community

Loading…

A welder in Gary bet me 20 bucks I couldn't hand-tighten a 3/4 inch tube roll, and now I check torque before every seal | Boilermakers - Babble Community