Miter saw fence drifted after a big job and I almost lost a finger

I was trimming out a whole basement in Akron last Saturday and by the 14th cut my Dewalt miter saw was suddenly off by 4 degrees, I caught it right as I went to rip a long piece of crown. Took me 20 minutes to realize the fence bolts had worked loose from all the vibration, never even thought to check mid-project. Anyone else torque those down with threadlocker or do you just keep a wrench on the bench and recheck every few hours?

0 comments

Log in to join the discussion

Log In

0 Comments

No comments yet

Be the first to share your thoughts on this discussion.